Pickful
Crypto community, better in app
40 Post
transnineelectric
¡ 1mo
A Buchholz relay is the gas- and oil-actuated device mounted in the pipe between a liquid-filled transformer's tank and its conservator. Slow gas buildup from an incipient fault drives an alarm; a fast oil surge from a severe fault trips the unit off the system. It catches winding turn-to-turn fa...
Before anyone touches an oil-immersed transformer for service, testing, or fault work, it has to be brought to a verified zero-energy state and bonded to ground. In U.S. practice that means de-energize both the high- and low-voltage sides, apply Lockout/Tagout, test for absence of voltage, then a...
The S20 oil-immersed transformer is normally set on a concrete pedestal at least 300 mm (about 12 in) above finished grade, with a perimeter drainage channel that keeps the tank base clear of standing water. Pole-mounted versions follow a different rule entirely â roughly 2.5 m from grade to the ...
Any transformer steps voltage down or up, and the S22 is no exception â feed the high-voltage winding and you get a lower voltage on the other side; feed the low-voltage winding and you get a higher one. The ratio is simply the turns ratio: U2 / U1 = N2 / N1. What actually decides whether an S22 ...
A rising top-oil temperature on an oil-immersed transformer is the single most useful early warning you will ever get. Left alone, it shortens insulation life, degrades the oil, softens the thermal margin on the windings, pressurises the tank, and eventually turns a local fault into a fire or a t...
for a cast resin dry-type transformer in a clean, indoor, ventilated room running at or below about 80% load, start from a monthly visual check, a quarterly service visit, a semi-annual electrical check and one annual outage â then move each of those intervals up or down using four site variables...
Lightning protection for a cast resin dry-type transformer is not one device â it is a chain of three jobs: intercept the strike before it reaches the equipment, clamp the overvoltage that arrives on the conductors anyway, and give the current a low-impedance path to earth without lifting the loc...
An EV charging transformer rarely dies from being worked too hard. On a DC fast-charging site the unit sits at 10â25% of nameplate for most of the day, so winding temperatures stay low and thermal ageing is slow. What actually kills these units is everything that happens while they are idle: cond...
When you're specifying power equipment for a mall, an office tower, or a mixed-use commercial complex, three things decide whether the electrical room becomes a headache or a non-issue: safety, energy cost, and noise. Conventional dry-type transformers burn more power than they need to, demand re...
Share with your followers.
Reply