Pickful
Crypto community, better in app
40 Post
transnineelectric
· 3w
A dry-type transformer is built to live inside a specific temperature envelope. The usual service condition is an ambient that never tops +40°C, with a daily average under +30°C and an annual average under +20°C, and an installation altitude at or below 1000 m. From there, the winding temperature...
The S20 oil-immersed transformer is a silicon-steel distribution unit rated 80–2500 kVA with primary voltages around 10–35 kV and a 60 Hz variant available on request. It is built to China's GB 20052-2020 Tier 2 efficiency grade and is quoted with roughly 10% lower no-load and load losses than th...
The S20 is a silicon-steel, oil-immersed distribution transformer that sits one tier above S11 and S13 on China's GB 20052 efficiency ladder. The case for specifying it comes down to lower losses, a tightly built core and winding, simple upkeep, tolerance for rough site conditions, and built-in o...
China sorts oil-immersed transformers into three efficiency tiers — Grade 1, Grade 2, and Grade 3 — under GB 20052, set by no-load and load-loss limits rather than a single efficiency percentage. An S13 lands at Grade 3, the minimum; you need an S20-class core or better to reach Grade 2. The 2024...
There is no single safe distance for an oil-immersed transformer. Chinese codes quote 5–6 m from buildings (GB 50053-94, GB 50016-2006) and 1.5–3 m from combustibles, fire gear, and roadways. The U.S. uses a different rule: NEC Article 450 and NFPA 850/851 set the spacing by installation type, oi...
Amorphous alloy transformers are rated on China's GB 20052 scale from grade 1 (best) to grade 5, and the grade tracks two numbers that hit your budget: no-load loss (P₀) and load loss (Pₖ). U.S. buyers don't see those grades — they check DOE 10 CFR 431 Subpart K compliance and the loss values on ...
· 4w
A transformer fits the job when its voltage, capacity, cooling, and insulation line up with the load and the site — not when the nameplate looks impressive. Start with the primary and secondary voltages, size the kVA to about 75–80% of the continuous load, then weigh oil against dry, short-circui...
Amorphous alloy and dry-type describe two different things. The first is the core material — amorphous metal versus conventional silicon steel. The second is the cooling medium — air/dry versus oil. An amorphous transformer can be either dry-type or oil-immersed, so the two are not two competing ...
· 1mo
Amorphous alloy describes the core material, not the cooling method — so an amorphous transformer comes in both forms. You can buy a dry-type cast-resin unit (the SCBH family) or an oil-immersed unit (the SH/SBH family). The core cuts no-load losses 70–80% below silicon steel either way; the dry-...
The SCB14 cast-resin dry-type transformer is a non-flammable, low-maintenance unit built for data centers, hospitals, and commercial buildings where fire safety is non-negotiable. This procedure lays out the pre-start checks, energizing and shutdown steps, monitoring, and emergency actions that k...
Share with your followers.
Reply